JUNCTION DETAILS

These Right-Angle sensors feature a thermal junction of thin ribbons welded together at the sensing tip. These ribbons are brought out from opposing sides of the probe between the interface of an insulating rod and cone assembly. The ribbons in the vicinity of the media being measured are parallel to the plane of the heat source, thus both the ribbons and the thermal junction are heated simultaneously and conduction errors are eliminated. The ribbon elements also allow for fast response times to temperature change since there is a large surface area to cross-section area ratio in the ribbon design as compared to round wires. This assembled ribbon junction is then installed into a special thermowell which has a 0.015" thick diaphragm on its tip. Thus the thermal junction is now in intimate thermal contact with the SS diaphragm. This produces an electrically grounded thermal junction. When an ungrounded junction is desired, a thin disc of electrical insulating material is inserted between the junction and the diaphragm, special attention is made to use a material with good heat transfer properties.

ORDERING INFORMATION

When ordering specify:
. Part No. C6 and ANSI Type. Example. C6-J
. For electrically ungrounded units add suffix (U), and increase price by $25.00. Ex. P/N-C6-J-U.

PRICE: $225.50 each for ANSI Types J, K, E aits add suffix (U), and increase price by $25.00. Ex. P/N-C6-J-U.

PRICE: $225.50 each for ANSI Types J, K, E and T, contact factory for other calibrations