PROBE
DETAILS
This
series of "Right Angle" Thermocouples feature a
Dust Deflector on the sensing tip. This deflector is in the
shape of an arc and it covers a 120 deg. angle around the
sensing tip. When foreign matter such as dust particles, dirt,
small solid objects are interspersed within the flowing hot
gases or liquids, these objects will impact the dust deflector
and be diverted off to the sides of the probe; thus protecting
the thin ribbon elements from damage. The thermal junction
measures the temperature of the hot gases and/or liquids
without being damaged by the dust particles. A peen mark is
stamped onto the thermowell at the cold end to assist in aligning
the probe so that the dust deflector is facing directly into
the oncoming gas flow. |
JUNCTION
DETAILS
These
Right-Angle sensors feature a thermal junction of thin
ribbons welded together at the sensing tip. These ribbons are
brought out from opposing sides of the probe between the interface
of an insulting rod and cone assembly. The ribbons in the vicinity
of the media being measured are parallel to the plane of the
heat source, thus both the ribbons and the thermal junction are
heated simultaneously and conduction errors are eliminated.
The ribbon elements also allow for fast response times to temperature
change since there is a large surface area to cross-section
area ratio in the ribbon design as compared to round wires.
Detailed information
about conduction
errors 
can be found in the Resource Center.
|
|
FEATURES
•Thermocouple
Junction has NO conduction errors.
•Low
millisecond response time to temperature changes.
•Pressure
range to 4000 PSI.
•Temperature
range from -320 to +2000 Deg. F.
•Available
in ANSI Types J, K, E and T.
•Standard
probe comes with a 2-prong standard plug connector attached.
Mating jack connector with cable clamp (not shown) is furnished
with each unit. .
Contact
factory for special units and other calibrations, refer
to C5 Series thermocouples
Wht="_parent">Contact
factory for special units and other calibrations, refer
to C5 Series thermocouples
When
ordering specify: Part
No. C5 and ANSI Type. Example: C5-J
|
