All NANMAC C4 Series Ejector Pin
Thermocouples come standard with a 24 inch, stainless steel
clad extension "stem", with a transition adaptor
and 3 feet of flexible shielded extension leads. All leads
join the Thermocouple/ Ejector Pin at 90° angle to allow
normal operation of most ejector pins. If specified, these
leads can join the thermowell on the longitudinal axis. In
addition, they can be of different lengths and have various
length flexible leads attached.
For
additional information on these as well as other high-performance
plastics thermocouples, refer to the PDF article Selecting
the Right Thermocouples 
in the resource center.
ORDERING
INFORMATION
When ordering Ejector
Pin thermocouples, specify the appropriate dimensions (A,
B, C, D) as shown on the above drawing, and the required thermocouple
type T, J, E or K.
Example: if you
require a thermocouple that has an overall length (A) of 9.5
in. with a shank length (B) of 8.75 in., a shank diameter
(C) of 0.375 in., a collar diameter (D) of 1.5 in., and type
K calibration, specify.. Part
Number: C4-1-9.5-8.75-0.375-1.5-K
Since the cost of C4 Series Thermocouples depends largely
on the particular dimensions required, it is not possible
to establish a price list to cover every need. Therefore,
please send your requirements as described above along with
a drawing if possible of your ejector pin for a price and
delivery proposal.In addition to plastics, these thermocouples
can also be used in zinc die casting, aluminum casting and
glass bottle manufacturing operations. Send
us your dimensional requirements together with maximum
service temperature and pressure requirements for a prompt
price and delivery proposal.
|
